Figure 2-1: Installing The Card Into The Chassis - Advantech CompactPCI MIC-3000 Series User Manual

backplane of the chassis. The inject/eject handles of MIC-3366 help you install and
remove the card easily and safely. Follow the procedure below to install the
MIC-3366 into a chassis:
To install a card:
1. Hold the card vertically. Be sure that the card is pointing in the correct direction.
The components of the card should be pointing to the right-hand side.
2. Pull out both handles to unlock it.
Caution: Keep your fingers away from the hinge to prevent your fingers from getting
pinched.
3. Insert the card into the c hassis by sliding the upper and lower edges of the card
into the card guides.
4. Push the card into the slot gently by sliding the card along the card guide until the
handles meet the rectangular holes of the cross rails. Note: If the card is correctly
positioned and has been slid all the way into the chassis, the handle should match
the rectangular holes. If not, remove the card from the card guide and repeat step
3 again. Do not try to install a card by forcing it into the chassis.
5. Pull the upper handle down and lift the lower handle up to push the card into
place.
6. Secure the card by pushing in the red handle to lock it into place.
To remove a card:
1. Unscrew the screws on the front panel.
2. Lift the upper handle up and press the lower handle down to release the card from
the backplane.
3. Slide the card out.

Figure 2-1: Installing the card into the chassis

MIC-3366 Series User Manual -- Page 16