Specifications - Advantech CompactPCI MIC-3000 Series User Manual

contain two Fast Ethernet interfaces, secondary serial port, one USB port, one VGA
connector, and one PS/2 keyboard/mouse connector. The front panel also has a
reset button and LEDs for power status, HDD operation and Ethernet
communication. The built-in high speed IDE controller provides two separate IDE
channels with Ultra DMA/33 mode. The user-defined J3 connector is designed to
support up to four IDE devices and two floppy drives. These drives can simply be
connected to the backplane or to the rear transition board for easy service and
maintenance.
Meets Industrial and Computer- Telephony Applications Requirements
The MIC-3366 is designed for use in mission critical applications. It accepts a
CompactFlash™ memory card (optional) on either the rear transition board or
MIC-3366 itself, thus eliminating the need to use a fragile rotating hard drive. A
watchdog timer can automatically reset the system if the system stops due to a
program bug or EMI. The two-layer front panel design complies with IEEE 1101.10.
Connectors are firmly screwed to the front panel, and the replaceable shielding
gasket is attached to the panel edge. This reduces emissions and gives better
protection against external interference.

1.2 Specifications

Standard SBC Functions
• CPU: BGA2 Low Power Pentium® III Coppermine CPU 700 MHz
• BIOS: Award 2 Mb flash memory
• Chipset: Intel® 440GX / 440BX Chipset
• Front Side Bus Clock: 100 MHz for Intel® Pentium® III CPU
• Bus Interface: 32-bit, 33 MHz, PICMG 2.0 compliant
• 2nd level cache: CPU built-in 256 KB (Pentium® III) on die
• RAM: Two 144-pin SO-DIMM sockets. Support PC-100 SDRAMs with memory
capacity up to 1GB (MIC-3366) and 512MB for MIC-3366B. Support ECC.
• Enhanced IDE interface: Two channels handles up to 4 IDE HDDs or other IDE
devices via J3 connector. Supports PIO mode 4 and Ultra DMA/33 mode.
• Floppy disk drive interface: Supports up to two floppy disk drives through the
J3 connector
• Serial ports: Two RS-232 ports with 16C550 compatible UARTs
• USB interface: One USB connector with fuse protection. Complies with USB
specification 1.0
• Keyboard/mouse connectors: One 6-pin mini-DIN connector on the front panel
• Watchdog timer: Can generate a system reset. Software enabled/disabled. Time
MIC-3366 Series User Manual -- Page
3