Hide thumbs Also See for MIC-1810:

Advertisement

Quick Links

MIC-1810
Intel
Core™ i3-3217UE/ Celeron
®
Embedded Automation Computer
Startup Manual
Packing List
Before you begin installing your card, please make sure
that the following items have been shipped:
1. MIC-1810 system x 1
2. Adapter 100-240V 60W 12V WO/PFC
DC PLUG 90°
3. MIC-1810 Startup manual x1
4. User note for MIC-1810
If any of these items are missing or damaged, please con-
tact your distributor or sales representative immediately.
Caution: DANGER OF EXPLOSION IF BATTERY IS INCOR-
RECTLY REPLACED. REPLACE ONLY WITH THE
SAME OR EQUIVALENT TYPE RECOMMENDED
BY THE MANUFACTURER, DISCARD USED BAT-
TERIES ACCORDING TO THE MANUFACTURER'S
INSTRUCTIONS.
Attention: DANGER D'EXPLOSION SI LA BATTERIE EST
INEXACTEMENT REMPLACÉE. REMPLACEZ
SEULEMENT AVEC LA MÊME CHOSE OU LE TYPE
ÉQUIVALENT RECOMMANDÉ PAR LE FABRICANT,
JETTENT LES BATTERIES UTILISÉES INSTRUC-
TIONS DE S SELON FABRICANT DES'.
For more information on this and other Advantech
products, please visit our website at:
http://www.advantech.com
http://www.advantech.com/Products
For technical support and service, please visit our
support website at:
http://support.advantech.com.tw/support/default.
aspx
This manual is for the MIC-1810 Series Rev. A1.
Part No. 2001181000
Printed in Taiwan
P/N: 96PSA-A60W12R1-1
P/N: 2001181000
P/N: 2061750000
1st Edition
December 2016
1047UE
®
Specifications
Processor System
• Intel
3rd Generation Core ™ i Processer with QM77
®
Chipset
Memory
• 4G SO-DDR3-1600 204Pin 512MX8 1.35V
Graphics
• Intel
HD Graphics 4000, support DirectX11
®
Serial Ports
• 2 x RS-232 from COM1/COM2
Ethernet
• Interface: 10/100/1000 Mbps
• Controller:
LAN1 : QM77 (MAC) + 82579LM GbE (PHY)
LAN2 : 82583V Gigabit Ethernet Controller
Storage
• Internal 2.5" SSD Bay: 1
Front I/O
• Display : 1 x VGA / 1 x HDMI
• USB: 2 x USB3.0; 2 x USB2.0
Power Requirement
• Power type: DC POWER JACK
• Power input Voltage: 12 V
Miscellaneous
• Power Switch
(Orange: System standby/Green:System Power boot)
Table Mount (Optional)
• P/N: 1960077844N001
• Dimension(W x L): 130 x 175 mm
Environment
• Operation Temperature:
0 ~ 50° C with 0.7m/S air flow: with 1x industrial SSD
• Relative Humidity: 95% @ 40° C (non-condensing)
Physical Characteristics
• Dimension (WxHxD): 165 x 130 x 59 mm
• Weight: 1.45 kg
DC
MIC-1810 Startup Manual 1

Advertisement

Table of Contents
loading

Summary of Contents for Advantech MIC-1810

  • Page 1 • Dimension (WxHxD): 165 x 130 x 59 mm http://support.advantech.com.tw/support/default. • Weight: 1.45 kg aspx This manual is for the MIC-1810 Series Rev. A1. Part No. 2001181000 1st Edition December 2016 Printed in Taiwan MIC-1810 Startup Manual 1...
  • Page 2: Analog Input

    SNR : 68 dB ENOB : 10.5 bits Low : 0.8V max. ; High : 2.0V min. External Digital Trigger Min. pulse width : 50 ns Range : -10V ~ +10V External Analog Trigger Resolution : 12-bit (4.88mV/step) 2 MIC-1810 Startup Manual...
  • Page 3: Hdd Installation

    DAQ Specifications (Cont.) Simple Maintain Process (Cont.) Counter Table-Mount Installation MIC-1810 provides a table mount to fix. To avoid overheat, Counter chip the side of heat sink must be upward. Channels 2 channels (independent) 1. Undo 4 screws. Resolution 32-bit 2.
  • Page 4: System Dimensions

    System I/O Interface System Dimensions 4 MIC-1810 Startup Manual...
  • Page 5 MIC-1810 Intel® Core™ i3-3217UE/ Celeron 1047UE微型计算机 快速入门手册 包装清单 产品规格 处理器系统 安装板卡之前,用户需确认包装中含有本设备以及下面所 列各项: • Intel第三代Core i处理器,带QM77芯片组 1. MIC-1810系统 x 1 内存 2. 适配器100-240V 60W 12V WO/PFC DC PLUG 90° P/N:96PSA-A60W12R1-1 • 4G SO-DDR3-1600 204针512MX8 1.35V 3. MIC-1810快速入门手册 x1 P/N:2001181000 显示 4. MIC-1810用户指南...
  • Page 6 0.8 V max.@ +15mA(灌电流) ± 输出电压 偏移误差:可调至0 高 2 V min.@ -15mA(拉电流) 增益 输入负载 10KΩ上拉电阻,连接至 5V 增益 精度 误差 (%FSR) 通道 单端/差分 类型 SNR:68 dB ENOB:10.5 bits 低:最大0.8V; 外部数字量 高:最小2.0V 触发 最小脉冲宽度:50 ns 范围:-10V ~ +10V 外部模拟量 触发 分辨率:12-bit (4.88mV/step) 2 MIC-1810快速入门手册...
  • Page 7 最大0.8 V @+15mA 计数器输出 高 最小2.0 V @-15mA 频率测量 0.1%,输入信号频率 ≥ 40KHz 脉冲宽度测量 0.1%,输入信号频率 ≤ 40KHz 高级功能误差 脉冲输出 小于2%,输出频率 > 1MHz PWM输出 小于2%,输出频率> 1MHz 简易安装指导 HDD安装 1. 卸下4颗螺丝后移除底盖。 2. 从底盖上卸下用于固定SSD的4颗螺丝。 3. 插接SATA线缆/电源线后放回后盖并用4颗螺丝固定。 符合性声明 本品符合FCC规则第15款限制。操作符合下列两种情况: 1. 此设备不可产生干扰, 2. 本设备必须接受任何收到的干扰,但干扰可能导致意外 操作。 MIC-1810快速入门手册 3...
  • Page 8 系统I/O接口 系统尺寸 4 MIC-1810快速入门手册...

Table of Contents