Table of Contents
Advertisement
Table 2-1: MIC-3366 serial port default settings
Port Address Default
COM1 3F8, 3E8 3F8/IRQ4
COM2 2F8, 2E8 2F8/IRQ3
2.5 Ethernet Configuration (CN5)
The MIC-3366 is equipped with dual high performance 32-bit PCI-bus Fast Ethernet
interfaces which are fully compliant with IEEE 802.3u 10/100Base-TX specifications.
It is supported by all major network operating systems and is 100% Novell NE-2000
compatible. One on-board RJ-45 jack (CN5) provides convenient connection to the
network. Another one has to go through RIO module (RIO-3306) as well as COM
port. The medium type can be configured via the software program included on the
utility CD-ROM disc. (See Chapter 3 for detailed information.).
2.6 USB Connector (Rear I/O)
The MIC-3366 provides one USB (Universal Serial Bus) interface (CN8 of
RIO-3306C/S) via the rear I/O module panel. The USB interface gives complete plug
and play, hot attach/detach for up to 127 external devices. The MIC-3366 USB
interface complies with USB specification rev. 1.0 and is fuse protected. The USB
interface can be disabled in the system BIOS setup. The USB controller default is
"Enabled" but the USB keyboard support default is "Disabled".
2.7 PMC Connector (J11, J12, J14 & J21, J22, J24)
The MIC-3366 supports up to two PMC (PMC Mezzanine Card) modules by optional
on PCI bus 0. The default of MIC-3366 series is with one PMC site only. This 32-bit,
3.3 V PCI bus is available at connectors J11 and J12. J14 is used for PMC rear panel
I/O per the PMC specification (IEEE P1386.1/Draft 2.2). Front panel access is
provided for the PMC interface. Signals from PMC modules that support rear panel
I/O are routed out the rear of the board through backplane connector J3. A second
PMC position is also available as an option. This position replaces the EIDE drive
capability, front panel video, and Serial Port access. This 32-bit, 3.3 V PCI bus is also
available at connectors J21 and J22. J24 is used for PMC rear panel I/O per the PMC
specification (IEEE P1386.1/Draft 2.2) as optional. Rear panel I/O from this PMC site
is routed out the rear of the board through backplane connector J5.
2.8 Card Installation
The CompactPCI™ connectors are firm and rigid, and require careful handling while
plugging and unplugging. Improper installation of a card can easily damage the
MIC-3366 Series User Manual -- Page 15
Advertisement
Table of Contents
