Table of Contents
Advertisement
drivers. Files in subdirectory <CDROM>: \MIC3366\ADVANNET\HSMON are
designed to support the hot swap operation.
5.4 Installing the Hot Swap Software
1. Install the Hot Swap Driver on Windows* 2000/XP via PnP device detection:
a. After Windows* 2000/XP starts up, it will find a new device and display the
"New Hardware Wizard".
b. Click on "Next".
c. Select "Display a list of the known drivers for this device so that I can choose
a specific driver" and click on "Next".
d. Select "Have Disk"
e. Fill in the directory <CDROM>:\MIC3366\AdvanNet\WIN2K where the INF
locates, and click on "OK"
f. Select "Advantech MIC-3366" and click on "Next".
Then follow the instructions to complete the installation.
2. Install the Hot Swap Driver on Windows* 2000/XP manually:
a. Click on "Start".
b. Select "Settings".
c. Select "Control Panel".
d. Double-click on the "System" icon.
e. Click on "Hardware" tab.
f. Click on "Device Manager".
g. Under the "System devices", right-click on the "Base System Device".
h. Click on "Properities".
i. Click "Driver" tab and click on "Update Driver".
j. Click on "Next" to enter the Upgrade Device Driver Wizard.
k. Select "Display a list of the known drivers for this device so that I can choose
a specific driver" and click on "Next".
l. Select "Have Disk"
m. Fill in the directory <CDROM>:\MIC3366\WIN2K where the INF locates, and
click on "OK"
n. Select "Advantech MIC-3366" and click on "Next".
Then follow the instructions to complete the installation.
3. Installation the Hot Swap Driver on Windows* XP is similar to the Installation on
MIC-3366 Series User Manual -- Page 26
Advertisement
Table of Contents
