Advantech CompactPCI MIC-3000 Series User Manual page 42

Quick Power On Self Test
This category speeds up Power On Self Test (POST) after you power on the
computer. If this is set to Enabled, BIOS will shorten or skip some check items
during POST.
Enabled
Disabled (default)
First/Second/Third/Fourth Boot Device
The BIOS attempts to load the operating system from the devices in the sequence
selected in these items. The settings are Floppy, LS/ZIP,
HDD-0/HDD-1/HDD-2/HDD-3, SCSI, CDROM, LAN, and Disabled.
Swap Floppy Drive
Switches the floppy disk drives between being designated as A and B. Default is
Disabled.
Boot Up Floppy Seek
During POST, BIOS will determine if the floppy disk drive installed is 40 or 80 tracks.
360K type is 40 tracks while 760K, 1.2M and 1.44M are all 80 tracks.
Boot Up NumLock Status
The default value is On.
On (default)
Off
Gate A20 Option
Normal
Fast(default)
Typematic Rate Setting
Key strokes repeat at a rate determined by the keyboard controller. When enabled,
the typematic rate and typematic delay can be selected. The settings are:
Enabled/Disabled.
Enable quick POST
Normal POST
Keypad is numeric keys.
Keypad is arrow keys.
The A20 signal is controlled by keyboard
controller or chipset hardware.
The A20 signal is controlled by port 92 or chipset
specific method.
MIC-3366 Series User Manual -- Page 34