Table of Contents
Advertisement
4.1 Introduction
The MIC-3366 uses an Intel® C&T 69030 chipset as its AGP VGA controller. The
VGA controller has an integrated 4 MB SDRAM operating at 83 MHz, and can drive
CRT displays with resolutions up to 1600 x 1200 @ 64 K colors. It supports
interlaced and non-interlaced analog monitors (color and monochrome VGA) in
high-resolution modes while maintaining complete IBM VGA compatibility. Digital
monitors (i.e. MDA, CGA, and EGA) are NOT supported. Multiple frequency
(multi-sync) monitors are handled as if they were analog monitors.
4.2 Installation of SVGA Driver
The MIC-3366 is supplied with a utility CD- ROM disc that holds the necessary file for
setting up the VGA display under the directory \MIC3366\VGA. The contents and
pathnames of this directory are listed below:
• MIC 3366\VGA\Win95: VGA utility for Windows 95
• MIC 3366\VGA\Win98: VGA utility for Windows 98
• MIC 3366\VGA\WINNT: Utility for Windows NT 4.0
• MIC 3366\VGA\Win2kxp: VGA utility for Windows 2000 and XP
Complete the following steps to install the VGA driver. Follow the procedures in the
flow chart that apply to the operating system you are using with your MIC-3366.
4.3 Installation for Windows 95/98
1. Click Start, then Settings, then Control Panel. Start the "Display" applet program.
2. Select the "Settings" page, push the "Change Display Type" button.
3. Push the "Change" button in the "Adapter Type" area.
4. Push the "Have Disk" button and press "OK".
5. Specify the path to the new driver and press the <ENTER> key:
Example 1: Insert the drivers disk in the A: floppy drive,
and enter A:\.
Example 2: Type in the name of the directory where you copied
the drivers, either on your local hard drive or
on a network share.
Example 3: If you're not sure exactly where the drivers are,
choose the "Browse..." button are find them.
6. The "Select Device" dialog box will appear. Select the adapter that corresponds to
the one you installed in your machine and click OK.
7. Windows 95 will copy the display drivers to the proper directories on your system.
8. Continue choosing Close until asked to restart your machine from the "Systems
MIC-3366 Series User Manual -- Page 22
Advertisement
Table of Contents
