SMC Networks IP8001 Series Operation Manual page 64

(b00) Analog output setting
(C00) Calibration
<(C10) Check angle of
*22
feedback lever >
<(C20) Simple balance current
*23
adjustment >
*24
<(C30) Calibration >
Possible to select analog output proportional output (inC) and
reversed output (dEC).
Procedure
Hold down the set button (
1
for 1sec. or
parameter change mode.
2 Select proportional output (inC) or
reversed output (dEC) by UP or
DOWN button（
Hold down the mode button ( ) for
3
1sec. or longer to set output mode.
Mode button
Set button
≧1s
（ ）
（
＋
Proportional output
Possible to check the feedback lever angle, balance current
adjustment, zero/span
parameter initialize.
The angle of the feedback lever unit connected to the valve stem is
checked.
22: For adjustment procedure, see "(2) Check the angle of the feedback
lever" of "■Initial Adjustment".
Adjust the balance current of the torque motor.
23: For adjustment procedure, see "(3)Simple balance current
adjustment" of "■Initial Adjustment".
Adjust zero-span and PID constant automatically.
24: For adjustment procedure, see "4.Calibration" of " ■ Initial
Adjustment".
63
＋ )
longer to start
）.
or
≧1s
）
Reversed output
Fig. 44
adjustment, input current
LCD display
or
adjustment,
No.IP8S-OM00009