Check Angle Of Feedback Lever - SMC Networks IP8001 Series Operation Manual

2. Check angle of
feedback lever
Procedure
Select the parameter used in
3
section 2 to 5 by pressing the UP or
DOWN button (
down the set button (
1sec or longer.
The angle of the feedback lever unit connected to the valve stem
is checked. The calibration explained in section 4 can be
performed if the LCD display is between -30 and 30 in the
operation range of the actuator, but may not satisfy the specified
value of linearity. Therefore, as described in "
Feedback Lever", mount the positioner so that the feedback lever
is symmetrical about the center
Procedure
1 Apply the input current and supply
pressure, press the UP or DOWN
button ( ) in calibration mode
or
to select the angle (AnGL), and
then hold down the set button
( ) for 1sec or longer.
＋
2 The output of OUT1 is 0MPa
the valve stem is located at the end
position. Check the value on the
LCD display is between -30 and 30.
3 Rotate the
auto/manual
approx. 1/8 turn to the manual side
paying attention to the actuator
*6
operation .
OUT1 output reaches its maximum
4
and the valve stem is located at its
end position opposite the one in
clause 2. Confirm the LCD shows a
number between -30 and +30.
If the LCD displays shows bars
5
(----), indicating that the value
exceeds +/-30 at the end position,
readjust the
positioner so that the angle is within
the specified range.
6 After confirmation,
auto/manual switch screw to the
auto position and tighten it securely.
Then, hold down the mode button
( ) for 1sec. or more to return to
calibration mode selection screen.
20
or ) and holding
) for
＋
*4
.
*5
, and
pilot valve unit
switching screw
position of the
rotate the
LCD display
■
Connection of
LCD display
No.IP8S-OM00009