ILX Lightwave MPS-8033 Series User Manual page 72

LASer:MODulation:CW
Parameters
Notes
Examples
LASer:MODulation:FREQ
Parameters
Notes
Examples
7/01
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The LASer:MODulation:CW command selects the continuous wave mode.
None.
This command has the same effect as pressing the CW switch on the 8033 front panel.
In this mode, the pulse modulation is turned off.
"LAS:MOD:CW" action: Commands the unit to the continuous wave mode.
The LASer:MODulation:FREQ command selects one of the internal modulation modes.
The <nrf value> represents the internal modulation frequency. The optional <suffix unit> is the
IEEE−488.2 approved frequency suffix.
Legal modulation frequencies:160 Hz to 15 KHz (GPIB only)
270 Hz (front panel)
1000 Hz (front panel)
2000 Hz (front panel
Legal suffixes: HZ Hertz
KZ, KHZ Kilohertz
This command has the same effect as pressing the INT MODULATION switch on the 8033 front
panel.
If the <suffix> is not used, the default is HZ.
If frequencies other than 270, 1000 and 2000 Hz are selected, the front panel MODE indicators will
all be off.
"LAS:MOD:FREQ 2 KZ"action: Commands the 8033 to the 2000 Hz internal modulation mode.
"LAS:MOD:FREQ 1000"action: Commands the 8033 to the 1000 Hz internal modulation mode.
C O M M A N D R E F E R E N C E
GPIB Command Reference
C
D
F
C
D
F
4
C H A P T E R
OMMON
D
EVICE EPENDENT
P
RONT ANEL
OMMON
D
EVICE EPENDENT
P
RONT ANEL
55
MPS-8033 !