ILX Lightwave MPS-8033 Series User Manual page 60

CAL:
Notes
CAL:RECall
Parameters
Notes
Examples
CAL:START
Parameters
Notes
ExamplesExamples"CAL:START"
7/01
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The CAL: command path is used to get to the MPS−8033's laser output calibration commands.
The following commands can be reached directly from the CAL: command path.
CAL:RECALL
CAL:START
CAL:USER1
CAL:USER2
CAL:USER3
The proper test equipment should be set up in order for these commands to work. Calibration is
discussed in Chapter 6.
The CAL:RECALL command will cause the 8033 to recall the default calibration values.
None.
The 8033 can be calibrated by the user as described in Chapter 6. This command resets the unit to
the default calibration values. A user calibration is recommended after this command is executed.
This command is available via the GPIB only.
"CAL:RECALL"
The CAL:START command will cause the 8033 to begin the three point calibration procedure.
None.
This command will initiate the laser output power calibration. The device will be forced to CW mode,
milliwatt display and the laser will be turned ON to the first calibration value.
The proper test equipment should be set up in order for these commands to work. Calibration is
discussed in Chapter 6.
C O M M A N D R E F E R E N C E
GPIB Command Reference
C
D
F
C
D
F
C
D
F
4
C H A P T E R
OMMON
D
EVICE EPENDENT
P
RONT ANEL
OMMON
D
EVICE EPENDENT
P
RONT ANEL
OMMON
D
EVICE EPENDENT
P
RONT ANEL
43
MPS-8033 !