Ansi/Ieee-488.2 Definitions; Power-On Conditions; Default Parameters; Table 3.5 State Of The 8033 After *Rst - ILX Lightwave MPS-8033 Series User Manual

ANSI/IEEE-488.2 Definitions

The following sections contain the relevant definitions for syntax diagrams and syntax elements for
the GPIB commands, as defined by the IEEE−488.2 standard.

Power-on Conditions

At power−up, the 8033 initializes the device parameters with the same parameters as when the
instrument was last shut−off. However, the output is always off at power−up. The unit default
conditions may be recalled by using the *RST command.

Default Parameters

Except for suffixes there are no default values for omitted parameters. If a command is expecting a
parameter and none is entered, an error is generated. If a suffix is omitted the default suffix is
assumed.
However, if a reset is performed via a *RST command, the following parameters are set to the
default state shown in Table 3.5.

Table 3.5 State of the 8033 after *RST

OUTPUT:
MODE:
DISPLAY:
POWER: (8033/0x)
POWER: (8033/C1/L1/55)
POWER: (8033/C2/L2/65)
GPIB:
STEP:
7/01
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
R E M O T E O P E R A T I O N
ANSI/IEEE-488.2 Definitions
Off
CW
Setpoint Power in mW
1.000 mW
10.00 mW
20.00 mW
REMOTE
.001 mW (GPIB only)
3
C H A P T E R
31
MPS-8033 !