ILX Lightwave MPS-8033 Series User Manual page 70

EVEnt?
Parameters
Response
Notes
Examples
LASer:
7/01
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The EVEnt? query returns the value of the status event register.
None.
The response data is the binary sum of the following:
1 Output ON/OFF change
2 Interlock enabled/disabled
4 New measurement available
The events which are summarized in bit #0 of the Status Byte can be set by using the
ENABle:EVEnt command. The event status register is cleared when this command is sent or when
the *CLS command is issued.
"EVE?" response: 1, means the output status changed, (OFF to ON or ON to OFF).
The LASer: command path is used to get to the MPS−8033's laser control commands.
The following commands can be reached directly from the LASer: command path.
LASer:DEC
LASer:MODulation:CW
LASer:MODulation:FREQ?
LASer:OUTput
LASer:POWer
LASer:REFerence
LASer:STEP
C O M M A N D R E F E R E N C E
GPIB Command Reference
C
D
F
4096 Calculation Error
8192 Hardware Error
16384 Software Error
32768 Software Checksum Error
C
D
F
LASer:INC
LASer:MODulation:FREQ
LASer:MODulation?
LASer:OUTput?
LASer:POWer?
LASer:REFerence?
LASer:STEP?
4
C H A P T E R
OMMON
D
EVICE EPENDENT
P
RONT ANEL
OMMON
D
EVICE EPENDENT
P
RONT ANEL
53
MPS-8033 !