ILX Lightwave MPS-8033 Series User Manual page 102

Table A.2 Error Code Descriptions
Error Code
E−202
E−203
E−204
E−205
E−206
E−207
E−208
E−209
E−210
E−211
E−212
E−213
E−214
E−301
E−501
E−511
E−516
E−529
E−532
E−706
E−720 to E−975
7/01
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Error Message Reference
Explanation
<PROGRAM DATA> will not convert to valid type.
Security violation, command is not available without clearance.
<PROGRAM DATA> suffix type is not valid.
<PROGRAM DATA> is not a boolean value or word.
<PROGRAM DATA> will not convert to a signed 16 bit value.
<PROGRAM DATA> will not convert to an unsigned 16−bit value.
<PROGRAM DATA> will not convert to a signed 32 bit value.
<PROGRAM DATA> will not convert to an unsigned 32−bit value.
<PROGRAM DATA> will not convert to a floating point value.
<PROGRAM DATA> will not convert to a character value.
<PROGRAM DATA> will not convert to a byte array pointer.
<PROGRAM DATA> is incorrect block data length.
<PROGRAM DATA> length exceeds maximum.
A <RESPONSE MESSAGE> was ready, but controller failed to read it. (Query
error).
Interlock disabled output.
Control error disabled output.
Incorrect Configuration for Calibration Sequence to start.
Hardware error disabled output.
Illegal Modulation Frequency chosen.
Auto−calibration cycle aborted.
Invalid internal status reporting error.
A
C H A P T E R
85
MPS-8033 !