Gpib Command Reference Summary; Table 4.1 Command Reference - ILX Lightwave MPS-8033 Series User Manual

GPIB Command Reference Summary

This section contains all of the device−dependent commands for the 8033, listed in alphabetical
order. Sub−sections for each path are presented, listing all of the commands which are legal for that
path. The command path 'tree' structure is illustrated best in Figure 4.1 on page 41.

Table 4.1 Command Reference

Name
*CAL?
CAL:RECALL
CAL:START
CAL:USER1
CAL:USER2
CAL:USER3
*CLS
COND?
*DLF
DIS
DIS?
ENAB:COND
ENAB:COND?
ENAB:EVE
ENAB:EVE?
ENAB:OUTOFF
ENAB:OUTOFF?
ERR?
*ESE
*ESE?
*ESR?
EVE?
*IDN?
*IST?
LAS:DEC
LAS:INC
LAS:MOD:CW
LAS:MOD:FREQ
LAS:MOD:FREQ?
LAS:MOD?
LAS:OUT
LAS:OUT?
7/01
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
C O M M A N D R E F E R E N C E
Parameters
Expected Function
Used for the A/D calibration procedure.
NONE Used to recall the default calibration values.
NONE Used to start the laser output power calibration cycle.
NONE Used to set the first calibration point into memory.
NONE Used to set the second calibration point into memory.
NONE Used to set the third calibration point into memory.
Resets the Standard Event Register, Status Byte and Error Queue to
zero.
NONE Returns the value of the Condition register.
Used to force the 8033 to cease being a listener.
1 Turns the display on or off.
NONE Returns the display message or value.
1 Sets the enable register for Conditions.
NONE Returns the value of the Conditions enable register.
1 Sets the enable register for Events.
NONE Returns the value of the Event enable register.
1 Sets the enable register for Conditions/Events which turn the OUTPUT
off.
NONE Returns the value of the Outoff enable register.
NONE Returns errors generated since the last query.
Used to load the Standard Event Status Enable Register.
Determines which status bits can set the summary bit (bit 5) in the
Status Byte.
Causes the 8033 to return the value of the STANDARD EVENT
REGISTER.
NONE Returns the value of the Event register.
Causes the 8033 to return the DEVICE IDENTIFICATION string.
Read the current state of the IEEE−488.1 'ist' local message in the 8033.
NONE Used to decrement the output power by the STEP value.
NONE Used to increment the output power by the STEP value.
NONE Used to command the modulation to continuous wave.
1 Used to command the modulation frequency.
NONE Returns the modulation frequency (0 if CW).
NONE Returns the modulation frequency.
1 Used to turn the output ON or OFF.
NONE Returns the output ON/OFF status.
C H A P T E R
Notes about Syntax
MPS-8033
4
39
!