L O C A L O P E R A T I O N
2
C H A P T E R
Introduction to the MPS-8033 Front Panel
GPIB Address
When the unit is in LOCAL mode, pressing the LOCAL/ADR switch causes the GPIB address to be
displayed. The GPIB address may be changed by the following procedure. The usable GPIB
address range is 0 to 30.
1
2
3
4
ADJUST Section
The ADJUST section is located on the right side of the 8033 front panel. The ADJUST knob is used
to change the light output power, enter instrument calibration data or set the GPIB address.
Clockwise rotation of the knob increases the parameter value.
DISPLAY Section
The DISPLAY switch section is used to select the display mode. Optical power may be displayed in
linear (milliwatts), log (dBm) and relative log (dB) scales. Pressing the DISPLAY switch causes the
12
!
MPS-8033
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Press and release the LOCAL/ADR switch. If the current GPIB address is not on the
display, press and release LOCAL/ADR again.
Press and hold the SET REFERENCE switch.
Use the ADJUST knob to select the desired GPIB address.
Release the SET REFERENCE switch to set the address into memory.
Figure 2.4 GPIB Section
Local/ADR
Switch