ILX Lightwave MPS-8033 Series User Manual page 104

B
A P P E N D I X
Q S G
UICK TART UIDE
! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! !
This chapter contains information that allows you to quickly install, configure, and operate the MPS−
8033.
Installation
Check to make sure the voltage printed on the back panel of the instrument matches the power−line
voltage in your area. Connect the MPS−8033 to the proper AC power receptacle and turn the front
panel KEYLOCK switch to the "ON" position.
The following warnings must be observed whenever the MPS−8033 is in operation.
Failing to comply with these precautions could result in severe injury or death! These
warnings also apply to the service and repair of the instrument. The MPS−8033 is a
Class−1 Laser Product.
Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
Do not enable the laser when there is no fiber attached to the optical output connector.
The optical output connector is at the bottom right on the MPS−8033 front panel. The laser
is enabled by pressing the OUTPUT ON switch to the left of the optical output connector.
The laser is on when the green LED indicator above the switch is solidly lit.
Never look into the end of a fiber optic cable attached to the optical output of the MPS−
8033 when the device is operational.
The laser radiation is not visible to the human eye, but can seriously damage eyesight.
To avoid electrical shock hazard, connect the instrument to properly earth− grounded, 3−
prong receptacles only. Failure to observe this precaution can result in severe injury or
death.
87
MPS-8033
!
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com