Adjusting The Lifting Device - Fronius Robacta Reamer V Easy Operating Instructions Manual

Adjusting the lifting device

Adjusting the lift-
NOTE!
ing device
The lifting device is adjusted in the same way for all Robacta Reamer V cleaning
devices.
(5)
6
7
NOTE!
The cleaning cutter must not touch any welding torch components.
8
9
10
11
12
(1)
(3)
(6)
Manually push the lifting device (3) into its highest lift position and hold in place
Manually push the cleaning motor (4) and cleaning cutter to the cleaning position
- see diagram (5) for welding torch and spatter guard
- see diagram (6) for welding torch and insulating sleeve
Fix the cleaning motor (4) in this position in the lifting device (3) - tighten the screw
(2) on the lifting device
Complete a function test without the gas nozzle fitted: Move the lifting device manu-
ally to the uppermost position
- The cleaning cutter must close around the contact tip without touching it. If the
cleaning cutter touches the welding torch components, readjust the lifting device
Fit the gas nozzle to the torch neck
Complete a function test with the gas nozzle fitted: Move the lifting device manually
to the uppermost position
- The cleaning cutter must be inserted into the gas nozzle gently, without touching
it. If the cleaning cutter touches the welding torch components, readjust the lift-
ing device
Fit the protective covering to the cleaning device in its original position
Remove the protective covering (1)
1
Remove the gas nozzle from the torch
2
neck
Loosen the screw (2) on the lifting
3
device
Ensure that the lifting device (3) is in
4
its lowest lift position
Move the welding torch to the cleaning
5
(4)
position (approx. 1 - 2 mm / 0.039 -
0.079 in. above the protective cover-
(2)
ing, centrally with respect to the clean-
ing motor)
49