Ensuring That The Cleaning Device Is Depressurised - Fronius Robacta Reamer V Easy Operating Instructions Manual

Ensuring that the Attempt to briefly activate the cleaning device without any compressed air supply to
cleaning device check whether the cleaning device is depressurised. Proceed as follows:
is depressurised
1
2
Robacta Reamer V Easy and Robacta Reamer V Easy Han6P J:
3
-
-
Robacta Reamer V:
3
-
-
38
Take protective measures:
- The cleaning cutter, lifting device, gas nozzle clamping device, wire cutter and
parting-agent injection nozzle could start up. Therefore keep your body, espe-
cially your hands, face and hair, any objects and all clothing away from the com-
ponents referred to above
- Wear ear protection
- Wear protective goggles with side protection
Ensure that the cleaning device has been disconnected from the compressed air
supply
Briefly turn the "Cleaning" screw on the cleaning device 90° to the right, then turn it
straight back to its original position
If the cleaning device does not respond to the turning of the screw, the cleaning
device is depressurised
If the cleaning device responds to the turning of the screw, the cleaning device is still
connected to a compressed air supply.
If this is the case, you must disconnect the cleaning device from the compressed air
supply and check again that the cleaning device is depressurised before starting
work
Briefly turn the "Lifting device up/down" screw on the cleaning device 90° to the right,
then turn it straight back to its original position
If the cleaning device does not respond to the turning of the screw, the cleaning
device is depressurised
If the cleaning device responds to the turning of the screw, the cleaning device is still
connected to a compressed air supply.
If this is the case, you must disconnect the cleaning device from the compressed air
supply and check again that the cleaning device is depressurised before starting
work