Safety Measures In Normal Operation; Commissioning, Maintenance And Repair; Safety Inspection - Fronius Robacta Reamer V Easy Operating Instructions Manual

Safety measures Only operate the device if all safety devices are fully functional. If the safety devices are
in normal opera- not fully functional, there is a risk of
tion -
-
-
Any safety devices that are not functioning properly must be repaired before switching on
the device.
Never bypass or disable safety devices.
Before switching on the device, ensure that no one is likely to be endangered.
Check the device at least once a week for obvious damage and proper functioning of
safety devices.
-
-
-
-
-
Commissioning, It is impossible to guarantee that bought-in parts are designed and manufactured to meet
maintenance and the demands made of them, or that they satisfy safety requirements.
repair -
-
-
-
The housing screws provide the ground conductor connection for earthing the housing
parts.
Only use original housing screws in the correct number and tightened to the specified
torque.

Safety inspection

The manufacturer recommends that a safety inspection of the device is performed at
least once every 12 months.
A safety inspection should be carried out by a qualified electrician
-
-
-
-
For safety inspections, follow the appropriate national and international standards and
directives.
Further details on safety inspection and calibration can be obtained from your service
centre. They will provide you on request with any documents you may require.
10
injury or death to the operator or a third party,
damage to the device and other material assets belonging to the operator,
inefficient operation of the device.
Only use suitable original parting agent from the manufacturer.
Observe the information on the parting agent safety data sheet when handling part-
ing agent. The parting agent safety data sheet may be obtained from your service
centre or downloaded from the manufacturer's website.
Do not mix the manufacturer's parting agent with other parting agents.
If damage results from using a different parting agent, the manufacturer accepts no
liability. In addition, no warranty claims will be entertained.
Used parting agent must be disposed of properly in accordance with the relevant
national and international regulations.
Use only original spare and wearing parts (also applies to standard parts).
Do not carry out any modifications, alterations, etc. to the device without the manu-
facturer's consent.
Components that are not in perfect condition must be replaced immediately.
When ordering, please give the exact designation and part number as shown in the
spare parts list, as well as the serial number of your device.
after any changes are made
after any additional parts are installed, or after any conversions
after repair, care and maintenance has been carried out
at least every twelve months.