Adjust Gas Nozzle Clamping Device; Adjusting The Gas Nozzle Clamping Device - Fronius Robacta Reamer V Easy Operating Instructions Manual

Adjust gas nozzle clamping device

Adjusting the gas
nozzle clamping
device
Robacta Reamer V Easy Han6P J only:
risk of damage to the cleaning device and the welding torch if the gas nozzle
clamping device is not properly adjusted.
▶
▶
NOTE!
The gas nozzle clamping device is adjusted in the same way on the Robacta
Reamer V Easy and the Robacta Reamer V.
4
5
NOTE!
Only clamp the gas nozzle centrally above the cleaning motor.
CAUTION!
The gas nozzle clamping device must not be altered when using gas nozzles with an
outer diameter of 25 mm (0.98 inch) - the gas nozzle clamping device has already
been adjusted for use with gas nozzles with an outer diameter of 25 mm (0.98 inch)
at the factory.
When using gas nozzles with an outer diameter greater/less than 25 mm (0.98 inch),
the gas nozzle clamping device must be adjusted before using it for the first time
and each time a device is replaced.
Tighten the Allen screws on the guide bolts (1) and (2)
Robacta Reamer V only:
Move and check the TCP tip
NOTE!
Adjust the clamping device in such a
way that no reaction forces can be
transferred to the robot.
The gas nozzle must only be clamped
onto the cylindrical surface.
(1)
Loosen the Allen screws on the guide
1
(3)
bolts (1) and (2)
(2)
Move the welding torch to the cleaning
2
(4)
position
- centrally with respect to the clean-
ing motor
Using the adjusting screw (3), position
3
the clamping device (4) so that the
clamping device is on the gas nozzle
47