Screwing The Robacta Reamer V Easy Han6P J To The Underlying Surface; Screwing The Adjusted Cleaning Device And Installation Stand To The Underlying Surface - Fronius Robacta Reamer V Easy Operating Instructions Manual

Screwing the Robacta Reamer V Easy Han6P J to
the underlying surface
Screwing the
NOTE!
adjusted cleaning
device and Different fixings may be required to set up the installation stand depending on the
installation stand type of underlying surface (foundation).
to the underlying Fixings are therefore not included in the scope of supply of the installation stand. The
surface installer is responsible for selecting the right type of fixing.
1
2
NOTE!
Use the fixings supplied with the mounting plate to fasten the mounting plate to
the installation stand.
3
5
44
Place the optional installation stand on a level, firm and vibration-free surface (found-
ation)
- Position the installation stand in such a way that the distance the robot has to
travel to the cleaning device on the installation stand is as short as possible
Screw the installation stand to the underlying surface (foundation) using the appro-
priate fixings
4
6