Assembling The Prism Reflector - Nikon DTM-502 Series Instruction Manual

2-7. Assembling the Prism Reflector

Assemble the prism reflector referring to the Figure below.
2
Tribrach adapter
Leveling base W10
Tripod
1) Height Adjustment of Tribrach Adapter
Tribrach adapter can be adjusted to two heights
by sliding up and down the prism holder mount.
To change the height, first remove the height
adjustment screw from the tribrach adapter.
Slide the prism holder mount to align the height
adjustment screw holes and screw in the
adjustment screw again.
• When using the DTM-502 series Total Station, set the prism holder
NOTE
mount to the lower position.
2-12
Target plate for single prism
Prism
Tiltable single
prism holder
Target pole
Triple prism holder
Prism holder mount
Height adjustment
screw