Setting Up The Prism Reflector - Nikon Nivo 2.C Instruction Manual

Setting Up the Prism Reflector

1. Assemble the prism reflector as shown below.
2. Adjust the height of the tribrach adaptor (see
3. If necessary, change the direction of the prism (see
4. If you are using a single prism holder, set the position of the target plate (see
page
Detailed instructions for Step 2 through Step 4 are provided on the following pages.
Note – Nivo series must be used with the Tribrach W30 or W30b.
Height adjust-
ment adapter
is not used.
Tribrach
adapter 15
Tribrach
W30/W30b
Tripod
20).
Target plate for single prism
Prism C
Tiltable single
prism holder
page 20).
page
Total Station Nivo Series Instruction Manual
Preparation 2
Target pole
Triple prism holder
20).
1 9