Nikon DTM-502 Series Instruction Manual page 159

5) Mode Key [MODE] ...................................................................3-25
1. While Inputting PT/CD ......................................................................3-25
2. Quick Code Mode (from BMS)..........................................................3-26
[COD] .......................................................................3-27
6) COD Key
1. Updating Default CD..........................................................................3-27
2. Qcode Observation .............................................................................3-27
[HOT] ........................................................................3-28
7) HOT Key
1. Height of Target..................................................................................3-28
2. Temperature & Pressure .....................................................................3-28
3. Select Target-set..................................................................................3-28
4. Note ....................................................................................................3-29
[Bubble] .........................................................................3-30
8) Level
9) Lumi-guide On/Off
3-4. Applications ....................................................................... 3-32
1) HA Reset and Angle Operations
1. 0-Set
Setting the Horizontal Angle to 0 .......................................................3-32
2. Input
Inputting the Horizontal Angle ...........................................................3-32
3. Rept.
Recording a Foresight Point after Repeat Angle Measurement ..........3-33
4. F1/F2
Face1/Face2 Measurement .................................................................3-34
5. Hold
Horizontal Angle Hold........................................................................3-34
2) Instrument Station Setup
1. Known Stn
Station Setup with Known Coordinates or Azimuth...........................3-35
1-1. 1: Known→1:Coord
Sighting the BS (backsight) Point by Inputting Coordinates.....3-36
1-2. 1:Known→2:Angle
Sighting the BS (backsight) Point by Inputting Azimuth
Angle .........................................................................................3-38
2. Multiple Point Resection
Setup Station by Angle/Distance Measurements to Known Points ....3-39
3. Quick Station (Quick)
Setup the Station Quickly without Given Coordinates .......................3-43
4. Remote Benchmark (RBM)
Determine Station Elevation...............................................................3-44
[LG] ............................................................3-31
[ANG] ...................................3-32
[STN] ................................................3-35
3
ii