TP-Link T2600G Series User Manual page 1055

2
SNMP Configurations
To complete the SNMP configuration, choose an SNMP version according to network
requirements and supportability of the NMS application, and then follow these steps:
■ Choose SNMPv1 or SNMPv2c
1) Enable SNMP.
2) Create an SNMP view for managed objects.
3) Create a community, specify the accessible view and the corresponding access rights.
■ Choose SNMPv3
1) Enable SNMP.
2) Create an SNMP view for managed objects.
3) Create an SNMP group, and specify the security level and accessible view.
4) Create SNMP users, and configure the authentication mode, privacy mode and
corresponding passwords.
2.1 Using the GUI
2.1.1 Enabling SNMP
Choose the MAINTENANCE > SNMP > Global Config to load the following page.
Figure 2-1 Configuring Global Parameters
Follow these steps to configure SNMP globally:
1) In the Global Config section, enable SNMP and configure the local and remote engine
ID.
SNMP Enable or disable SNMP globally.
SNMP Configurations
User Guide 1026