TP-Link T2600G Series User Manual page 1038

Configuring OAM
Figure 4-6 OAM Event Logs
4.1.3 Using the CLI
1) Enable OAM and configure OAM mode as active on port 1/0/1.
Switch_A#configure
Switch_A(config)# interface gigabitEthernet 1/0/1
Switch_A(config-if)#ethernet-oam
Switch_A(config-if)#ethernet-oam mode active
2) Configure Link Monitoring on the port. Enable Event Notification and keep the threshold
and window as the default.
Switch_A(config-if)#ethernet-oam link-monitor symbol-period notify enable
Switch_A(config-if)#ethernet-oam link-monitor frame-period notify enable
Switch_A(config-if)#ethernet-oam link-monitor frame notify enable
Switch_A(config-if)#ethernet-oam link-monitor frame-seconds notify enable
3) Configure Remote Failure Indication on the port. Enable Dying Gasp Notification and
Critical Event Notification.
Switch_A(config-if)#ethernet-oam remote-failure critical-event notify enable
Switch_A(config-if)#ethernet-oam remote-failure dying-gasp notify enable
Configuration Example
User Guide 1009