TP-Link T2600G Series User Manual page 1078

■ Enabling the DDM Traps Globally
Note:
T2600G-52TS does not support DDM traps.
Step 1 configure
Enter Global Configuration Mode.
Step 2 snmp-server traps ddm [ temperature | voltage | bias_current | tx_power | rx_power ]
Enable the corresponding DDM traps. DDM function is used to monitor the status of the
SFP modules inserted into the SFP ports on the switch. The command without parameter
enables all SNMP DDM traps. By default, all DDM traps are disabled.
temperature:
switch. The trap can be triggered when the temperature of any SFP module has reached the
warning or alarm threshold.
voltage:
trap can be triggered when the voltage of any SFP module has reached the warning or alarm
threshold.
bias_current:
switch. The trap can be triggered when the bias current of any SFP module has reached the
warning or alarm threshold.
tx_power:
The trap can be triggered when the TX Power of any SFP module has reached the warning
or alarm threshold.
rx_power:
The trap can be triggered when the RX Power of any SFP module has reached the warning
or alarm threshold.
Step 3 end
Return to Privileged EXEC Mode.
Step 4 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to configure the switch to enable DDM temperature trap:
Switch#configure
Switch(config)#snmp-server traps ddm temperature
Switch(config)#end
Switch#copy running-config startup-config
■ Enabling the VLAN Traps Globally
Step 1 configure
Enter Global Configuration Mode.
Monitors the temperature of SFP modules inserted into the SFP ports on the
Monitors the voltage of SFP modules inserted into the SFP ports on the switch. The
Monitors the bias current of SFP modules inserted into the SFP ports on the
Monitors the TX Power of SFP modules inserted into the SFP ports on the switch.
Monitors the RX Power of SFP modules inserted into the SFP ports on the switch.
Notification Configurations
User Guide 1049