TP-Link T2600G Series User Manual page 1124

Configuring System Logs
message is generated. To display the logs, the servers should run a log server software
that complies with the syslog standard.
Choose the menu MAINTENANCE > Logs > Remote Logs to load the following page.
Figure 2-2 Configuring the Remote Logs
Follow these steps to configure the information of remote log servers:
1) Select an entry to enable the server, and then set the server IP address and severity.
Server IP
UDP Port
Severity
Status
2) Click Apply.
2.1.3 Backing up the Logs
Choose the menu MAINTENANCE > Logs > Back Up Logs to load the following page.
Figure 2-3 Backing up the Log File
Click Back Up Logs to save the system logs as a file on your computer. If the switch system
breaks down, you can check the file for troubleshooting.
Specify an IP address of the log server.
Displays the UDP port used by the server to receive the log messages. The switch
uses standard port 514 to send log messages.
Specify the severity level of the log messages sent to the selected log server.
Only log messages with a severity level value that is the same or lower than this
will be saved.
Enable or disable the log server.
System Logs Configurations
User Guide 1095