TP-Link T2600G Series User Manual page 1059

Read View
Write View
Notify View
2) Click Create.
2.1.5 Creating SNMP Users (For SNMP v3)
Choose the menu MAINTENANCE > SNMP > SNMP v3 > SNMP User and click
load the following page.
Figure 2-6 Creating an SNMP User
Follow these steps to create an SNMP user:
1) Specify the user name and user type as well as the group which the user belongs to.
Then configure the security level.
User Name
User Type
Group Name
Security Model
Choose a view to allow parameters to be viewed but not modified by the NMS.
The view is necessary for any group.
Choose a view to allow parameters to be modified by the NMS. The view in Write
View should also be added to Read View.
Choose a view to allow it to send notifications to the NMS.
Set the SNMP user name using 1 to 16 characters. For different entries, user
names cannot be the same.
Choose a user type based on the location of the user.
Local User: The user resides on the local engine, which is the SNMP agent of the
switch.
Remote User: The user resides on the NMS. Before configuring a remote user,
you need to set the remote engine ID first. The remote engine ID and user
password are used when computing the authentication and privacy digests.
Choose the name of the group that the user belongs to. Users with the same
Group Name, Security Model and Security Level will be in the same group.
Displays the security model. SNMPv3 uses v3, the most secure model.
SNMP Configurations
to
User Guide 1030