TP-Link T2600G Series User Manual page 1015

Configuring OAM
Maximum
OAMPDU
Remote
Loopback
Unidirection
Link Monitoring
Variable Request
PDU Revision
Vendor
Information
2.2 Using the CLI
2.2.1 Enabling OAM and Configuring OAM Mode
Follow these steps to enable OAM and configure OAM mode on the port:
Step 1
Step 2
Step 3
Step 4
Step 5
Displays the maximum size of OAMPDU.
Displays whether the remote entity supports Remote Loopback.
Displays whether the remote entity supports Unidirection.
Displays whether the remote entity supports Link Monitoring.
Displays whether the remote entity supports Variable Request.
Displays the PDU Revision of the remote entity.
Displays the vendor information of the remote entity.
configure
Enter global configuration mode.
interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list }
Enter interface configuration mode.
ethernet-oam
Enable OAM on the port.
ethernet-oam mode { passive | active }
Configure the OAM mode of the port.
passive: Specify the OAM mode as passive. The port in this mode cannot initiate OAM
connection or send Loopback Control OAMPDU.
active: Specify the OAM mode as active. The port in this mode can initiate OAM connection.
It is the default setting.
Note : OAM connection cannot be established between two ports in passive mode. Make
sure that at least one side is in active mode.
show ethernet-oam configuration [ interface fastEthernet { port | port-list } | interface
gigabitEthernet { port | port-list } | ten-gigabitEthernet { port | port-list } ]
Verify the OAM configuration.
Ethernet OAM Configurations
User Guide 986