TP-Link T2600G Series User Manual page 1019

Configuring OAM
Gi1/0/1
-----------------------------------------------------------
...
Frame Error
Notify State
Window
Threshold
...
Switch(config-if)#end
Switch#copy running-config startup-config
■ Configuring Error Frame Period Event
An Error Frame Period event occurs if the number of frame errors in specific number of
received frames exceeds the defined threshold.
Follow these steps to configure the Error Frame Period event:
Step 1
Step 2
Step 3
Step 4
Step 5
: Enabled
: 2000 milliseconds
: 1 Error Frame
configure
Enter global configuration mode.
interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list }
Enter interface configuration mode.
ethernet-oam link-monitor frame-period [threshold threshold ] [window window ] [notify
{disable | enable}]
Configure the relevant parameters of Error Frame Period.
threshold : Specify the threshold of received symbol errors in specific number of received
frames. Valid values are from 1 to 4294967295, and the default value is 1.
window
: Specify the number of frames, in which if the frame errors exceed the threshold, a
link event will be generated. Valid values are from 148810 to 89286000, and the default value
is 1488100.
disable | enable: Enable or disable the port to report the failure condition.
show ethernet-oam configuration [ interface fastEthernet { port | port-list } | interface
gigabitEthernet { port | port-list } | ten-gigabitEthernet { port | port-list } ]
Verify the OAM configuration.
end
Return to privileged EXEC mode.
Ethernet OAM Configurations
User Guide 990