TP-Link T2600G Series User Manual page 1023

Configuring OAM
Critical Event
...
Switch(config-if)#end
Switch#copy running-config startup-config
2.2.4 Configuring Remote Loopback
Follow these steps to configure Remote Loopback:
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
The following example shows how to start the OAM remote loopback mode of the peer on
port 1/0/1:
Switch#configure
Switch(config)#interface gigabitEthernet 1/0/1
Switch(config-if)# ethernet-oam remote-loopback start
: Enabled
configure
Enter global configuration mode.
interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list }
Enter interface configuration mode.
ethernet-oam remote-loopback received-remote-loopback { process | ignore }
Configure the port to ignore or to process the received remote loopback request.
ethernet-oam remote-loopback { start | stop }
Request the remote peer to start or stop the OAM remote loopback mode. The port to be
configured here should be in active mode that has established OAM connection with the
peer.
show ethernet-oam configuration [ interface fastEthernet { port | port-list } | interface
gigabitEthernet { port | port-list } | ten-gigabitEthernet { port | port-list }]
Verify the OAM configuration.
end
Return to privileged EXEC mode.
copy running-config startup-config
Save the settings in the configuration file.
Ethernet OAM Configurations
User Guide 994