TP-Link T2600G Series User Manual page 1022

Configuring OAM
2.2.3 Configuring Remote Failure Indication
Follow these steps to configure Remote Failure Indication:
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
The following example shows how to enable Dying Gasp and Critical Event on port 1/0/1:
Switch#configure
Switch(config)#interface gigabitEthernet 1/0/1
Switch(config-if)#ethernet-oam remote-failure dying-gasp notify enable
Switch(config-if)#ethernet-oam remote-failure critical-event notify enable
Switch(config-if)#show ethernet-oam configuration interface gigabitEthernet 1/0/1
Gi1/0/1
-----------------------------------------------------------
...
Dying Gasp
configure
Enter global configuration mode.
interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list }
Enter interface configuration mode.
ethernet-oam remote-failure { dying-gasp | critical-event } notify { disable | enable }
Configure the Dying Gasp Notification and Critical Event Notification features on the port.
dying-gasp: Enable Dying Gasp Notification, and if the switch detects an unrecoverable fault
on the network, such as power failure, occurs, it will send Information OAMPDU to notify the
peer.
critical-event: Enable Critical Event Notification, and if the switch detects an unspecified
critical event occurs, it will send Information OAMPDU to notify the peer.
disable | enable: Enable or disable notification to report the link events.
show ethernet-oam configuration [ interface fastEthernet { port | port-list } | interface
gigabitEthernet { port | port-list } | ten-gigabitEthernet { port | port-list }]
Verify the OAM configuration.
end
Return to privileged EXEC mode.
copy running-config startup-config
Save the settings in the configuration file.
: Enabled
Ethernet OAM Configurations
User Guide 993