TP-Link T2600G Series User Manual page 1009

Configuring OAM
Mode
Status
2) Click Apply.
2.1.2 Configuring Link Monitoring
Choose the menu MAINTENANCE > Ethernet OAM > Link Monitoring > Link Monitoring
to load the following page.
Figure 2-2 Configure Link Monitoring
Follow these steps to configure Link Monitoring:
1) In the Link Event section, select a Link Event type to configure.
Select OAM mode for the port.
Active: The port in this mode can initiate OAM connection. It is the default setting.
Passive: The port in this mode cannot initiate OAM connection or send loopback
control OAMPDUs.
Note: OAM connection cannot be established between two ports in passive mode.
Make sure that at least one side is in active mode.
Enable or disable OAM on the port. By default, it is disabled.
Ethernet OAM Configurations
User Guide 980