TP-Link T2600G Series User Manual page 1086

3) Enter the owner name, and set the status of the entry. Click Apply.
Owner
Status
Note:
To change the parameters of a History entry, enable the entry at the same time; otherwise, the change
cannot take effect.
5.1.3 Configuring Event Group
Choose the menu MAINTENANCE > SNMP > RMON > Event to load the following page.
Figure 5-3 Configuring the Event Entry
Follow these steps to configure the Event group:
1) Choose an Event entry, and specify an SNMP User for the entry.
Index
User
2) Set the description and action to be taken when the event is triggered.
Description
Enter the owner name of the entry with 1 to 16 characters. By default, it is
monitor.
Enable or disable the entry. By default, it is disabled.
Enable: The entry is enabled.
Disable: The entry is disabled.
Displays the index of Event entries. The switch supports up to 12 Event entries.
Choose an SNMP user name or community name for the entry. Only the specified
user can access the log messages or receive the notification messages related to
the event.
Enter an brief description of this event to make it easier to be identified.
RMON Configurations
User Guide 1057