TP-Link T2600G Series User Manual page 1048

Configuring DLDP
Switch(config)#dldp
Switch(config)#dldp interval 10
Switch(config)#dldp shut-mode auto
Switch(config)#show dldp
DLDP Global State: Enable
DLDP Message Interval: 10
DLDP Shut Mode: Auto
Switch(config)#end
Switch#copy running-config startup-config
The following example shows how to enable DLDP on port 1/0/1.
Switch#configure
Switch(config)#interface gigabitEthernet 1/0/1
Switch(config-if)#dldp
Switch(config-if)#show dldp interface
Port DLDP State
---- ----------
Gi1/0/1 Enable
Gi1/0/2 Disable
...
Switch(config-if)#end
Switch#copy running-config startup-config
Protocol State Link State
-------------- ----------
Inactive Link-Down
Initial Link-Down
DLDP Configuration
Neighbor State
--------------
N/A
N/A
User Guide 1019