TP-Link T2600G Series User Manual page 1047

Configuring DLDP
2.2 Using the CLI
Follow these steps to configure DLDP:
Step 1
Step 2
Step 3
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
The following example shows how to enable DLDP globally, configure the DLDP interval as
10 seconds and specify the shutdown mode as auto.
Switch#configure
configure
Enter global configuration mode.
dldp
Globally enable DLDP.
dldp interval interval-time
Configure the interval of sending advertisement packets on ports that are in the
advertisement state.
interval-time : Specify the interval time. The valid values are from 1 to 30 seconds. By
default, it is 5 seconds.
dldp shut-mode { auto | manual }
Configure the DLDP shutdown mode when a unidirectional link is detected.
auto:
The switch automatically shuts down ports when a unidirectional link is detected. It is
the default setting.
manual: The switch displays an alert when a unidirectional link is detected. Then the users
can manually shut down the unidirectional link ports.
interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list }
Enter interface configuration mode.
dldp
Enable DLDP on the specified port.
show dldp
Verify the global DLDP configuration.
show dldp interface
Verify the DLDP configuration of the ports.
end
Return to privileged EXEC mode.
copy running-config startup-config
Save the settings in the configuration file.
DLDP Configuration
User Guide 1018