Ink Refill Assy - Brother HL-J6000DW Service Manual

9.41 Ink Refill ASSY

(1) Remove the Ink supply tube from the Support wire.
(2) Remove the Ink supply tube from the Tube support plate.
(3) Release the wiring of Carriage motor harness attached to the Ink refill ASSY.
(4) < Ink tank model / Simple Ink cartridge model only >
Peel off the Cable band just from the Ink sensor flat cable.
Note: Do not remove the Cable band from the Lower cover to reuse it when mounting
a new Ink refill ASSY.
(5) Release the wiring of the Ink sensor flat cable from the Lower cover.
(6) < Ink tank model only >
Remove the two screws (TAPTITE CUP B M3x10) from the Ink refill ASSY.
(7) Remove the Ink refill ASSY from the Lower cover.
< Ink cartridge model >
Ink supply tube
Tube support plate
Support wire
< Ink tank model >
Ink supply tube
Tube support plate
Support wire
Routing of harnesses: See
Ink sensor flat cable
2
2
2
1
Hooks
Cable band
(Simple Ink cartridge model only)
Fig. 3-136
TAPTITE CUP B M3x10
Ink sensor flat cable
2
2
2
1
Hooks
Cable band
Fig. 3-137
2
" Main PCB/Modem
3-111
Ink refill ASSY
7
Lower cover
Ink refill ASSY
7
Lower cover
PCB".
Confidential