Brother HL-J6000DW Service Manual page 312

Note: If an error occurs, the machine beeps and displays "Error No **" on the LCD.
Press the Stop key to return to the initial stage of the maintenance mode and
then recover the machine from the error state, following the table given below.
Then go back to step (3).
Error The following error has
code occurred.
Failed to detect the external
01
frame.
Internal image inclined.
02
Failed to detect position.
03
Failed to write head
04
calibration data.
The uneven printing
correction function for upper
and lower ends of the nozzle
05
is disabled with Maintenance
88.
Cannot get data due to
06
memory full.
The document scanner unit
07
is open.
Scanning errors other than
09
the above.
With a media being inserted,
the USB cable or LAN cable
10
is connected.
The scanner cover is open.
11
Do the following:
- Clean the document cover glass.
- Reset the print pattern so that the ▲ mark
is aligned with the left rear of the document
cover without tilt.
- Check that there is no block missing.
- Go back to step (2) and print out "Print
pattern for creating head calibration data"
again.
Clean the document cover glass.
-
Reset the print pattern so that the
-
is aligned with the left rear of the document
cover without tilt.
Check that there is no block missing.
-
Restart the machine and perform the
-
procedure from the beginning again.
Replace the main PCB.
-
- Set selector 1 on AMS05 to "0" (ON) in
"1.3.34 Assurance Mode Switch Setting
(Maintenance mode 88)"
Delete fax data and other data stored in the
-
memory.
Replace the main PCB.
-
Close the document scanner unit.
-
Reconnect the document scanner sensor
-
harness.
- Replace the document scanner if the boss
that presses the document scanner sensor
is broken.
Replace the main PCB.
-
Use "1.3.15 Acquisition of White/Black
-
Level Data (Maintenance mode 55)"
chapter.
Disconnect the USB cable or LAN cable.
-
Close the scanner cover.
-
5-8
mark
▲
in this chapter.
in this
Confidential