Brother HL-J6000DW Service Manual page 235

(12)Release the wiring of the Maintenance unit.
(13)Remove the two screws (TAPTITE CUP B M3x10) from the CR frame ASSY.
Assembling Note: When assembling the two screws (TAPTITE CUP B M3 x 10),
(14)Remove the two screws (TAPTITE CUP B M3x10) from the CR guide rail.
Assembling Note: When assembling the two screws (TAPTITE CUP B M3 x 10),
CR frame ASSY
(15)Remove the screw (<Made-in-China machine> TAPTITE CUP B M3x10, <Made-
in-Philippines machine> TAPTITE BIND B M4x12) and the two screws (SCREW
BIND M3x6) from the Maintenance unit.
SCREW BIND M3x6
temporarily remove the screw in step (3) of
first. Then, assemble the two screws in the order as shown in the
figure, and lastly reassemble the temporarily removed screw.
assemble them in the order as shown in the figure.
TAPTITE CUP B M3x10
2
Fig. 3-123
Maintenance unit
Fig. 3-124
3-103
TAPTITE CUP B M3x10
1
1
2
"9.47 Carriage Motor"
CR guide rail
<Made-in-China machine>
TAPTITE CUP B M3x10
<Made-in-Philippines machine>
TAPTITE BIND B M4x12
Confidential