Brother HL-J6000DW Service Manual page 209

(7) Remove the two CIS roller holder from the First side CIS unit.
(8) Disconnect the First side CIS flat cable from the First side CIS unit and remove the
First side CIS unit from the CIS holder.
Note: When removing the First side CIS unit, be careful not to lose the CIS spring.
CIS roller holder
Pin
First side CIS
flat cable
CIS spring
(9) Peel off the First side CIS flat cable which is secured at three locations with the
Double-sided adhesive tape from the Scanner base ASSY.
(10)Pull out the First side CIS flat cable from the Hole of the Scanner base ASSY.
(11)Peel off the FFC film which is secured with Double-sided adhesive tape from the
First side CIS flat cable.
Double-sided adhesive tape
Scanner base ASSY
7
8a
8b
Pin
Pin
Fig. 3-76
Double-sided adhesive tape
First side CIS flat cable
FFC film
9
10
Hole
Double-sided adhesive tape attachment position
Fig. 3-77
3-77
First side CIS unit
CIS roller holder
7
CIS holder
9
9
Double-sided adhesive tape
attachment position
Pin
CIS spring
Double-sided
adhesive tape
attachment
position
CIS holder
Confidential