Brother HL-J6100DW Quick Setup Manual

HL-J6000DW / HL-J6100DW
Quick Setup Guide
Read the Product Safety Guide first, then read this Quick Setup Guide
for the correct installation procedure.
Unpack the machine and check the components
1
The components included in the box may differ depending on your country.
Remove the protective tape or film covering the machine.
Inbox Ink Cartridges*
• Black
• Yellow
• Cyan
• Magenta
*Inbox ink cartridges contain the
following yield of replacement
LC3237 cartridges:
Watch our FAQ videos for help
- Black: approx. 75% yield
with setting up your Brother
- Others: approx. 65% yield
machine.
uu Reference Guide: Supply
support.brother.com/videos
2 Load plain A4 paper
For more information about paper handling and sizes, see the Reference Guide.
Pull the paper tray completely out of
the machine as shown by the arrow.
Connect the power
3
cord
(Example for UK)
NOTE
You can adjust the control panel angle to read the
touchscreen more easily.
6
Set the date and time
Follow the touchscreen instructions to set the date and time.
Quick Setup Guide
Product Safety Guide
Brother Installation Disc
Specifications
Fan the paper well.
Select your country
4
or language
(Initial setup only)
After turning the machine on, you may need to set your country
or language (depending on your machine).
If required, follow the touchscreen instructions.
7
Machine settings
Follow the touchscreen instructions to configure the
machine's settings:
• View operation tips
• Set Brother LCD Message defaults
• Check print quality
• Configure the tray or paper size settings
• Print the installation sheet
The latest manuals are available at the Brother Solutions Center:
support.brother.com/manuals
Power Cord
Maintenance Sheet
Do not exceed this
mark (bbb).
Adjust the paper guides.
Load the paper in the tray.
5
Install the inbox ink cartridges
Open the ink cartridge cover.
NOTE
• The Reference Guide for these models is available on the
enclosed installation disc.
• Most of the illustrations in this Quick Setup Guide show the
HL-J6000DW.
• Save all packing materials and the box in case you must ship your
machine.
• You must purchase the correct interface cable for the
interface you want to use.
USB cable
Use a USB 2.0 cable (Type A/B) that is no more than 5 metres
long.
Ethernet (Network) cable
Use a straight-through Category 5 (or greater) twisted-pair cable
for 10BASE-T or 100BASE-TX Fast Ethernet Network.
Secure Network Access
Your machine's default password is initpass. We
recommend you change it to protect your machine
from unauthorised access.
Slowly push the paper tray Pull out the paper support
completely into the machine. until it locks into place.
Quickly shake just the
black ink cartridge
horizontally 15 times as
shown, before inserting it
into the machine.
Select your language
8
(if needed and only for
certain models)
1.
Press [Settings] > [All Settings] >
[Initial Setup] > [Local Language].
2.
Press your language.
3.
Press .
D012E1001-00
UK
Version 0
Follow the touchscreen
instructions to unpack and
install the ink cartridges.
Close the ink cartridge cover.
The machine will prepare the
ink tube system for printing.
NOTE
The first time you install a set
of ink cartridges the machine
will use an amount of ink to fill
the ink delivery tubes for high
quality printouts. This process
will only happen once.