Adf Document Support - Brother HL-J6000DW Service Manual

9.17 ADF Document Support

(1) Remove the screw (TAPTITE CUP B M3x10) and remove the ADF document size
FG wire 1 and ADF document size FG wire 2.
(2) Disconnect the Connector from the ADF document size harness unit.
ADF document
support
(3) Release the two Pins and turn the ADF document support to the position shown in
the figure.
(4) Release the two Bushings. While removing the Harness, remove the ADF
document support from the ADF unit.
ADF unit
ADF document size FG wire 1
Connector
Fig. 3-55
Pin
Bushing
4b
3
Fig. 3-56
3-65
TAPTITE CUP B M3x10
ADF document size FG wire 2
2
ADF document size harness unit
Pin
Bushing
4a
Harness
ADF document support
Confidential