Table of Contents
Advertisement
Installation Guide Linear Motors
4.3 Mounting the flange
The motor is leveled and attached by means of the mounting threads at both ends of the stator. The hole
pattern is shown on p. 15 in the Dimensions section.
4.4 Mounting the payload to the slider
The load is mounted as a fixed bearing using spherical washers and conical seats (see the section on Slider
accessories / mounting kits)
To avoid shear force on slider and wear on stator, the payload has to be supported by a linear guide.
When attaching the load, the wrench for tightening the load must be used only on the load-
facing side of the slider.
It is important to avoid torsional stress on slider (note figure below).
Slider
27 mm
NTI AG / LinMot
Thread
M 10
P01-48-HP EX protected
ENG
Max. torque for screw
47 Nm
Page 29 / 47
Advertisement
Table of Contents
