Table of Contents
Advertisement
Installation Guide Linear Motors
4.5 «Moving slider» installation
In a "moving slider" installation, the stator is fixed and the slider is the moving part.
The load, borne by a linear guide, is attached directly to the end of the slider. In order to compensate for
misalignment, spherical axial bearings consisting of spherical washers and conical seats (see the section 5.1
Slider mounting kit fixed bearing) are used to connect to the load. The mounting kit of slider and an
oversized hole for the screw make it possible to adjust a radial and angle offset.
Page 30 / 47
Stator
Linear guide
P01-48-HP EX protected
Incorrect assembly
Torsional stress on slider
Correct assembly
Spherical washer and
Slider
conical seat
Linear bearing
Mounted payload with radial and angle offset
ENG
NTI AG / LinMot
Advertisement
Table of Contents
