Brake Hold - Toyota C-HR Owner's Manual

212
4-2. Driving procedures

Brake Hold

The brake hold system keeps the brake applied when the shift
lever is in D, B or N with the system on and the brake pedal has
been depressed to stop the vehicle. The system releases the
brake when the accelerator pedal is depressed with the shift
lever in D or B to allow smooth start off.
Turns the brake hold system on
The brake hold standby indicator
(green) comes on. While the sys-
tem is holding the brake, the brake
hold operated indicator (yellow)
comes on.
■
Brake hold system operating conditions
The brake hold system cannot be turned on in the following conditions:
●
The driver's door is not closed.
●
The driver is not wearing the seat belt.
If any of the conditions above are detected when the brake hold system is
enabled, the system will turn off and the brake hold standby indicator light will
go off. In addition, if any of the conditions are detected while the system is
holding the brake, a warning buzzer will sound and a message will be shown
on the multi-information display. The parking brake will then be set automati-
cally.
C-HR_HV_OM_General_OM10653E