Table of Contents
Advertisement
156
3-2. Opening, closing and locking the doors
●
If the electronic key is inside the vehicle and a door handle becomes wet
during a car wash, a message may be shown on the multi-information dis-
play and a buzzer will sound outside the vehicle. To turn off the alarm, lock
all the doors.
●
The lock sensor may not work properly if it comes into contact with ice,
snow, mud, etc. Clean the lock sensor and attempt to operate it again.
●
A sudden approach to the effective range or door handle may prevent the
doors from being unlocked. In this case, return the door handle to the origi-
nal position and check that the doors unlock before pulling the door handle
again.
●
If there is another electronic key in the detection area, it may take slightly
longer to unlock the doors after the door handle is gripped.
●
Fingernails may scrape against the door during operation of the door han-
dle. Be careful not to injure fingernails or damage the surface of the door.
■
When the vehicle is not driven for extended periods
●
To prevent theft of the vehicle, do not leave the electronic key within 2 m
(6 ft.) of the vehicle.
●
The smart entry & start system can be deactivated in advance. (P. 571)
■
To operate the system properly
Make sure to carry the electronic key when operating the system. Do not get
the electronic key too close to the vehicle when operating the system from the
outside of the vehicle.
Depending on the position and holding condition of the electronic key, the key
may not be detected correctly and the system may not operate properly. (The
alarm may go off accidentally, or the door lock prevention function may not
operate.)
■
If the smart entry & start system does not operate properly
●
Locking and unlocking the doors: Use the mechanical key. (P. 543)
Starting the hybrid system: P. 544
●
C-HR_HV_OM_General_OM10653E
Advertisement
Table of Contents
