142
3-2. Opening, closing and locking the doors
■
Switching the door unlock function
It is possible to set which doors the entry function unlocks using the wireless
remote control.
Turn the power switch off.
1
When the indicator light on the key surface is not on, press and hold
2
approximately 5 seconds while pressing and holding
The setting changes each time an operation is performed, as shown below.
(When changing the setting continuously, release the buttons, wait for at least
5 seconds, and repeat step
Multi-information
display
(Left-hand drive
vehicles)
(Right-hand drive
vehicles)
For vehicles with an alarm: To prevent unintended triggering of the alarm,
unlock the doors using the wireless remote control and open and close a door
once after the settings have been changed. (If a door is not opened within 30
seconds after
automatically be set.)
In a case that the alarm is triggered, immediately stop the alarm. (P. 103)
C-HR_HV_OM_General_OM10653E
.)
2
Unlocking function
Holding the driver's door
handle unlocks only the
driver's door.
Holding the front passen-
ger's door handle unlocks
all the doors.
Holding
a
door
unlocks all the doors.
is pressed, the doors will be locked again and the alarm will
.
Beep
Exterior: Beeps 3 times
Interior: Pings once
handle
Exterior: Beeps twice
Interior: Pings once
for