Understanding The 48 V Battery System - Toro Greensmaster eTriFlex 3360 Operator's Manual

Figure 48
1. Right side cover
2. Bolt
1. Remove the right side cover.
2. Remove the battery cover.
3. Disconnect the battery cables from the batteries.
4. Connect the charger to the battery terminals and
charge the battery.
Note the following information for your battery
charger:
•
Ensure that the battery-charger connectors
do not contact each other or the machine
frame. Using smaller connectors is
recommended.
•
A battery charger with an AGM-charging
setting is preferred.
•
Maximum charge current: 2.4 A
•
Maximum charge voltage: 14.3 V
5. Connect the battery cables to the battery when
the charge is completed.
6. Install the battery cover over the battery.
7. Install the right side cover.
g291736
3. Battery cover
4. 12 V battery
Understanding the 48 V
Battery System
Important:
Charging the 48 V battery system is
not recommended.
The 48-V battery system consists of 4 12-V AGM
batteries. 2 batteries are located on both sides of
the machine (4 total); refer to
provides power to the traction wheels, cutting-unit
motors, steering motor, and lift actuators.
1. 48 V battery system
44
Figure 49. This system
Figure 49
g279163